, Chiyoda, Tokyo, Japan) was used to characterize the morphology of the samples. The crystal structure of the TiO2 nano-branched arrays was examined by X-ray diffraction (XRD; XD-3, PG Instruments Ltd., Beijing, China) with Cu Kα radiation (λ = 0.154 nm) at a scan rate of 4° per min. X-ray tube voltage and current were set to 36 kV and 20 mA, Blasticidin S order respectively. The optical absorption spectrum was obtained using a UV-visible spectrometer (TU-1900, PG Instruments, Ltd., Beijing, China). Solar cell assembly and performance measurement Solar cells were this website assembled
using nano-branched TiO2/CdS nanostructures as photoanodes. Pt counter electrodes were prepared by depositing a 20-nm-thick Pt film on FTO glass MK-2206 cost using magnetron
sputtering. A 60-μm-thick sealing material (SX-1170-60, Solaronix SA, Aubonne, Switzerland) with a 5 × 5 mm2 aperture was pasted onto the Pt counter electrodes. The Pt counter electrode and the nano-branched TiO2/CdS photoelectrode were sandwiched and sealed with the conductive sides facing inward. A polysulfide electrolyte was injected into the space between the two electrodes. The polysulfide electrolyte was composed of 0.5 M sulfur, 1 M Na2S, and 0.1 M NaOH, all of which were dissolved in methanol/water (7:3, v/v) and stirred at 80°C for 2 h. A solar simulator (Model 94022A, Newport, OH, USA) with an AM1.5 filter was used to illuminate the working solar cell at a light intensity of 1 sun illumination (100 mW/cm2). A sourcemeter (2400, Keithley Instruments Inc., Cleveland, OH, USA) provided electrical characterization during the measurements. Measurements were calibrated using an OSI standard silicon solar photodiode. Results and discussion Figure 1 shows the typical FESEM images of TiO2 nanorod arrays on Carnitine dehydrogenase FTO-coated glass substrates, at both (a)
low magnification and (b) high magnification. It can be observed that the FTO-coated glass substrate was uniformly covered with ordered TiO2 nanorods. The density of the nanorods was 20 nanorods/μm2, which allows suitable space for growth of TiO2 nanobranches. After immersion in an aqueous TiCl4 solution for a period of time ranging from 6 to 24 h, nanobranches appeared along the trunks of the TiO2 nanorods. The morphology of the branches, shown in Figure 2, is strongly dependent on the amount of time the nanorods remain immersed in the TiCl4 solution. As the immersion time increases, the branches become greater in number and longer in length. These branches coated on TiO2 nanorod would greatly improve the specific surface area and roughness, which is urgent for solar cell applications. However, when immersed for 24 h or more, the branches form continuous networks that greatly suppress the effective surface area, preventing the CdS quantum dots from fully contracting with the TiO2 and therefore decreasing the overall photovoltaic performance.