The stratification impacted on dormancy release in three differen

The stratification impacted on dormancy release in three different ways: (i) dormancy was consistently released with prolonged stratification time when stratified at temperatures of < 15 degrees C; (ii) at 15 degrees C and 20 degrees C, the stratification effect initially increased, and then decreased with extended time; and (iii) stratification at 25

degrees C only reduced germinable seeds. These behaviours indicated that stratification could not only release primary dormancy but also induce secondary dormancy in grape seed. The rate of dormancy release changed linearly in two phases, while induction increased exponentially with increasing temperature. The thermal time approaches effectively quantified dormancy release only at suboptimal temperature, but a quantitative method to integrate the occurrence of dormancy release and induction at the same time could describe it well at either sub- or supraoptimal temperatures. The regression Daporinad nmr with the percentage of germinable PKC412 concentration seeds

versus stratification temperature or water content within both the sub- and supraoptimal range revealed how the optimal temperature (T-so) and water content (W-so) for stratification changed. The T-so moved from 10.6 degrees C to 5.3 degrees C with prolonged time, while W-so declined from > 0.40 g H2O g DW-1 at 5 degrees C to similar to 0.23 g H2O g DW-1 at 30 degrees C. Dormancy release in grape seeds can occur across a very wide range of conditions, which has important implications for their ability to adapt to a changeable environment in Selleck Prexasertib the wild.”
“Changes in a perfluorosulfonated acid polymer membrane in membrane electrode assemblies were studied after different times under stationary

conditions in fuel cells. A large series of characterizations demonstrated changes in the morphology, mechanical behavior, and thermal stability upon aging. Overall, the membrane evolution could be mainly attributed to both chemical degradation and cationic contamination. The reduction in the membrane thickness, detected by scanning electron microscopy, was ascribed to a radical unzipping mechanism and polymer chain erosion after 900 h in service. An additional monotonic decrease in the number of C(tertiary)F groups was observed even at 400 h. In parallel, membranes were cation-contaminated, and this led to drastic changes in the thermal and mechanical properties in the first stage of fuel-cell operation. The pollution cations were shown to have Lewis acid strengths close to 0.25 and thus strongly interacted with sulfonate anions of the membrane. The kinetic dependence of these membrane modifications and the influence of the platinum band were also examined. (C) 2010 Wiley Periodicals, Inc. J Appl Polym Sci 117: 2121-2132, 2010″
“We derive the calibration constants necessary for using single-walled carbon nanotubes (CNTs) as nanoscale mass sensors. The CNT resonators are assumed to be either in cantilevered or in bridged configurations.

Comments are closed.