0 g, 8.3 mmol) and ethylendiamine (4.2 g, 70 mmol) were dissolved in EtOH (210 mL) and refluxed for 18 h. The solvent was removed by evaporation, and the residue was dissolved in an aqueous HCl solution (1 M, 333 mL). An aqueous NaOH solution (1 M) was added carefully to the solution with magnetic stirring. The precipitate was recovered by filtration, washed thoroughly with water, and then dried under vacuum, yielding (1) as a pink fluffy powder (3.21 g, 80%); 1H NMR (CDCl3): δ (ppm) 7.85
(d, 1H, LY2835219 J = 2.5 Hz), 7.44 (t, 2H, J = 6.7 Hz), 7.06 (s, 1H), 6.42 to 6.37 (m, 6H), 3.33 (q, 10H, J = 7.1 Hz), 2.91 (t, 2H, J = 6.7 Hz), 1.16 (t, 12H, J = 6.7 Hz); 13C NMR (CDCl3): δ (ppm) 170.5, 153.7, 153.3, 149.1, 133.2, 130.0, 128.4, 128.3, 123.9, 123.2, 108.6, 103.6, 97.8, 66.4, 44.4, 41.1, 39.5, 12.66. Figure 1 shows the synthesis to obtain derivative (1). Figure 1 Synthesis to obtain derivative (1). The Rh-UTES
derivative was obtained by following the next procedure (Figure 2): In a 10-mL round-bottom flask fitted with magnetic stirrer, m-xylenediisocyanate (0.05 g, 0.26 mmol) and 3-aminopropyltriethoxysilane (APTES) (0.04 g, 0.18 mmol) were refluxed in 5 mL of toluene under N2 for 12 h. Derivative (2) was used without isolation, the Rh-amine derivative (1) was added (0.1 g, 0.21 mmol) under N2, and the reaction was refluxed for 3 h. The solvent AZD8186 cell line was evaporated under reduced pressure to give a beige powder (0.22 g, 96%); 13C NMR (DMSO-d 6): δ (ppm) 168.0, 158.1, 154.2, 153.0, 148.1, 141.0, 133.2, 130.5, 128.6, 128.5, 126.2, 126.1, 126.0, 125.9, 125.7, 124.0, 122.8, 108.3, 105.3, 97.8, 64.6, 60.2, 44.1, 43.4, 40.6, 38.4, 21.2, 15.1, 14.5, 12.8; IR data: ν max (cm-1): 3331, 2970 to 2890, 1695, 1624, 1574, 1513, 1082, 962, 771. Figure 2 Synthesis of Rh-UTES (3). PSi device functionalization The binding of Rh-UTES derivative within the PSi nanostructured devices was performed following one-step method through silane chemistry by reacting the methoxy groups (-OCH3)3 of the fluorescent molecule with the siloxane (-Si-O) groups of the thermally oxidized PSi surface [18]. Briefly, the PSi samples were dipped in 2 mL of Rh-UTES derivative solution
(1.16 μM PLEK2 in ACN) at room temperature, and all of the reaction system was kept under inert atmosphere with magnetic stirring. The reaction time was fixed at 3 h to obtain the final PSiMc/Rh-UTES sensors. Metal capture Once obtained, the PSiMc/Rh-UTES sensors were exposed to 2.0 mL of mercury aqueous solutions. To assure the presence of the free Hg2+ ions, the solutions were adjusted at pH 3.0 using HNO3 0.1 M (based in the Hg speciation diagram). The complexation reactions were carried out at room temperature for 12 h under magnetic stirring.