For the samples of ZnO/ZnSe NRs prepared by depositing click here ZnSe whether at RT or at 500°C (samples B, C, and D), the ZnSe (LO) mode at approximately 255 cm−1 is unambiguously recognized. Furthermore, a weak peak corresponding to the ZnSe 2LO mode at approximately 500 cm−1 can also be identified [16, 17, 21] as shown by the inset in Figure 4. However,

the Raman scattering attributed to the ZnO A1 (LO)/E1 (LO) modes is greatly suppressed due to the ZnSe coatings on the ZnO NRs. The above Raman scattering results obtained with 488- and 325-nm light excitation together confirm not only the wurtzite structure of ZnO cores and the zinc blende structure of ZnSe shells but also the improvement in crystal structures of both the ZnO cores and ZnSe shells by elevated temperature deposition or by post-deposition annealing at elevated temperature. Figure 4 Raman spectra of samples A (a), B (b), C (c), and D (d), recorded by exciting the samples with 325-nm laser beam. The inset shows the Raman bands of ZnO/ZnSe

core/shell NRs (samples B, C, and D in the downward order). The FTIR measurements provide a further evidence for the formation of wurtzite buy Belinostat ZnO and zinc blende ZnSe and the influences of deposition temperature and post-deposition annealing. Figure 5 displays the FTIR transmission spectra recorded for the samples. The FTIR transmission spectrum of sample A presents typical characteristics of the IR properties of ZnO. In addition to the absorption of the Si substrate, the principal

IR absorption peaks are located in the wavenumber Morin Hydrate range from 340 to 470 cm−1, with one absorption peak near 381 cm−1 and another one appearing as a shoulder around 415 cm−1. They could be assigned to the stretching modes of Zn − O − Zn. Compared with the bare ZnO NRs, the FTIR spectra of all the ZnO/ZnSe NR samples distinguish themselves with a prominent absorption near 207 cm−1 which corresponds to the TO mode of ZnSe [24]. It is also noticed that this absorption peak appears much narrower and stronger for samples C and D, indicating that ZnSe in the samples submitted to high-temperature processing, either depositing ZnSe at 500°C or being annealed at 500°C, has better structure. Also for samples C and D which have experienced high-temperature processing, moreover, the absorption peaks attributed to ZnO exhibit a small red shift, as shown by the inset of Figure 5. These two absorption peaks shift to 378 and 409 cm−1, respectively, much close to the ωT// and the ωT⟂ frequencies of the ZnO TO modes [25], also indicating that the structure of the ZnO cores was improved during the high-temperature processing. Figure 5 FTIR transmission spectra recorded for samples A (a), B (b), C (c), and D (d). The inset shows the position of IR absorption of ZnO in bare ZnO NRs and in ZnO/ZnSe core/shell NRs (curves a, b, c, and d for samples A, B, C, and D, respectively). Optical properties The bare ZnO NRs are capable of emitting strong and stable UV luminescence (378.